Csspecs

Plastic buttplate with hollow flexible Polyurethane pad. Plate can be installed over the original Steel plate using the original screws.

OR you can install it alone. It adds about 1/2" to length of pull.

This is a 3D printed part based on laser scans of two rifles, some variation rifle to rifle can exist.

The parts also vary slightly in finish and texture.

Polyurethane isn't rubber, it's halfway between plastic and rubber. It's a firm material, roughly like a shoe sole.

Naturally there is not a significant amount of recoil from a .22lr.. BUT having a grippy buttpad is slightly nicer because the stock stays anchored better, and it doesn't slide if set on a hard surface.